SysProfile ID47983 // DeepInside

Huii lue wies rockt weiter so

 

sry, für die späte Antowrt, also zu den 4.0Ghz einstellungen, müßten die gehen mit Quad

Hier ein typisches Setting für Quad OC

450FSB Quad-Core BIOS Settings

Ai Overclock Tuner [Manual]
OC From CPU Level Up [Auto]
CPU Ratio Control [Manual]
Ratio CMOS Setting: [9]
FSB Frequency [450]
FSB Strap to North Bridge [400MHz] oder [Auto]
PCIE Frequency [110]
DRAM Settings
DRAM Frequency [DDR2-1199MHZ] oder [800MHz] oder [Auto]
DRAM Command Rate [2T]
DRAM Timing Control [Manual]
CAS# Latency [5]
RAS# to CAS Delay [5]
RAS# Precharge [5]
RAS# Active Time [15]
RAS# To Ras# Delay [3]
Row Refresh Cycle Time [42]
Write Recovery Time [6]
Read To Precharge Time [3]
Read To Write Delay(S/D) [8]
Write To Read Delay(S) [3]
Write To Read Delay(D) [5]
Read To Read Delay(S) [4]
Read To Read Delay(D) [6]
Write To Write Delay(S) [4]
Write To Write Delay(D) [6]
DRAM Static Read Control [Disabled]
Ai Clock Twister [Strong]
Transaction Booster [Enabled]
Boost Level [0]
Voltage Settings
CPU Voltage [Was immer Deine CPU für 4GHz braucht, bei 1.5 beginnen]
CPU PLL Voltage [Auto] Hier später fixen um nicht zu stark zu overvolten
North Bridge Voltage [1.61v] austesten später erhöhen oder verringern
DRAM Voltage [2.15v]
FSB Termination Voltage [1.54v]
South Bridge Voltage [Auto]
Loadline Calibration [Enabled]
CPU GTL Reference [0.63x]
North Bridge GTL Reference [0.67x]
DDR2 Channel A REF Voltage [Auto]
DDR2 Channel B REF Voltage [Auto]
DDR2 Controller REF Voltage [DDR2_REF]
SB 1.5V Voltage [Auto]

grüße
KILLYOU2XXXTP